| Frame | Camera | Pose | Penetration | Evidence | Defects |
|---|---|---|---|---|---|
| 31701 | FAIL | PASS — supine, knees raised/spread, man kneeling between thighs | FAIL | Shaft runs vertically up from below the frame; glans and full shaft sit in front of the crotch panel, terminating against the velvet gusset. No occlusion by labia or thighs. | Garment gusset not pulled aside — reads as shaft pressed against fabric, not inside. Man's torso cropped to a featureless slab. |
| 31702 | FAIL | PASS — same missionary configuration | FAIL | Same vertical shaft, fully external; glans visible below the suit edge with clear gap between shaft and body plane. Shaft appears to originate from the man's abdomen, not from her. | Detached shaft: no continuous connection to the man's pelvis. Suit gusset intact, no pulled-aside edge. Man's hands appear at her hips but arms are absent. |
| 31703 | FAIL | PASS — missionary, knees up, man between thighs | FAIL | Shaft vertical and external, glans below the suit hem; junction obscured by the gusset rather than resolved by it. Cannot tell inside vs. beside. | Ambiguous junction — the exact failure mode clause V was meant to fix. Man's forearms terminate without hands on her thighs. |
| 31704 | FAIL | PASS — missionary, knees spread, man kneeling | FAIL | Shaft emerges from between the man's legs and rises past her crotch; the glans overlaps the suit hem but the shaft is in front of her thigh plane, not behind it. | Shaft reads as a separate column in front of the body. Man's hands grip her thighs correctly, but his arms are foreshortened into stubs. |
| 31705 | FAIL | PASS — she sits astride his lap facing camera, knees spread, weight down | FAIL | Shaft hangs downward between her thighs, glans fully visible below the crotch, pointing at the floor. Nothing is occluded; the shaft is a pendant, not an insertion. | Gravity-defying downward shaft — anatomically impossible for cowgirl. Man's head cropped at brow. Suit gusset intact, not pulled aside. |
| 31706 | FAIL | PASS — astride, knees spread, seated on his lap | FAIL | Shaft descends vertically from her crotch, glans and full length visible against the mattress; base disappears under the frame edge rather than into her. | Detached shaft again — no visible origin at his pelvis. Shaft orientation contradicts seated posture. |
| 31707 | FAIL | PASS — astride, knees spread, settled down | FAIL | Same downward pendant shaft; glans visible at bottom, shaft passing in front of her thigh rather than between labia. | Shaft floats in front of the body plane. Man's hands on her waist but his lap is not resolved — she appears to sit on air. |
| 31708 | FAIL | PASS — astride, knees spread, seated | FAIL | Shaft hangs straight down, glans clearly external and below the suit hem; no occlusion anywhere along its length. | Most explicit external-shaft failure in the set. Shaft disconnected from his pelvis; suit gusset uncut, no pulled-aside edge visible. |

**Pass rates:** Camera 0/8. Pose 8/8. Penetration 0/8.

The pose axis is the one thing this set got right — every frame is recognizably missionary or cowgirl, and the model's prior is holding. The camera axis is a total miss: none of the eight is genuinely overhead. They are all frontal or near-frontal, framed at chest height looking slightly down at most, with the girl's face centered and the junction at the bottom edge. That is the root cause of the penetration failure, not the insertion clause.

Because the camera is frontal, the shaft is rendered in the picture plane in front of the body rather than receding into it. In missionary frames the shaft stands vertically *in front of* the crotch panel; in cowgirl frames it hangs vertically *below* the crotch, which is geometrically impossible for a seated astride pose. In both cases the renderer resolves the ambiguity by drawing the whole shaft, glans included, external — exactly the FAIL condition. Clause A and clause V produced no measurable difference: 0/4 and 0/4 respectively.

Two secondary defects compound it. First, the suit gusset is never actually pulled aside — it sits intact across the junction in all eight frames, so the model has no visual cue that the fabric is displaced, and defaults to laying the shaft against it. Second, the shaft is frequently detached from the man's pelvis (31702, 31706, 31707, 31708), which removes the one depth cue that would force occlusion.

**Likely fix:** the above camera is not producing legible insertion because it was never achieved. Lock the camera to a true high angle — positioned above and behind the man's shoulder, pitched down 40–60° along the body axis, with her torso foreshortened and the junction in the upper-middle third of the frame. At that angle the shaft must recede away from camera into her body, and occlusion becomes the path of least resistance for the renderer. Pair it with explicit gusset displacement ("the velvet gusset hooked aside over her left hip, exposing the junction") so the model has a reason to place the shaft behind the fabric edge rather than on top of it. Consider dropping cowgirl until the camera fix lands — the seated geometry plus frontal camera is what produced the physically impossible pendant shaft in 31705–31708.